Hello, I have programmed an UC500 with 4BRI. I have set up BRI with VN3 and it is working well for incoming calls. But when i want to make an outgoing call it is not working. Thanks Mathias |
|||
 |
UC500.comCisco Communication Manager Express, UC520, SMB VOIP reference and community |
Add this : isdn map address
Add this :
isdn map address . plan unknown type unknown
under BRI Interface context.
It did the trick for me.
Adrien
Thanks Adrien. I will check
Thanks Adrien.
I will check this afternoon.
I have a pb with euro isdn too. Is there something particular to do for working with FT ? (with switch-type basit-net3 ?)
Mathias
UC500 BRI outgoing calls
Hi,
you must ad dial patterns in your call manager express system. By cli or GUI. I think your way is the GUI with your browser. ;-)
To connect to your "ccme" you must type in in the address row of your browser: 192.168.10.1/ccme.html (standard IP of the Data VLan) The you can add dial patterns and there's a help function that describes the way how to do this
thanks for your quick
thanks for your quick answer. I didn't notice that i have to do that via http interface.
There is no pb for me to do it via cli. It is just my first uc500.
Do you have cli example (i perfer do have this version, cause in case of pb it is more easy to verify the conf).
Regards
Mathias
I have set up an destination
I have set up an destination pattern. But without any success.
the NDI is 02 40 12 34 56 and the extension number is 201.
the rule set : 02401234.. 3 2..
Is this right ?
Do I have a pb with the isdn setup. I am located in france, the isdn is euroisdn+.
I have 4 BRI.
I have set up the BRI with net3s.
Incoming calls is working, but outgoing calls fail.
In debug mode, i saw that is connect the layer 2 (i thing the call routing is ok, if i saw that ?).
Do i have an tei pb ?
I try different way without any success.
I try isdn test call ... without success too.
Thanks for your help.
Hi, you need in global
Hi, you need in global config:
no dial-peer outbound status-check pots
Also, when you put the bri interfaces in trunk-group and reference that in the outbound DP, you may not need the above anymore.