Telnet does not work anymore

Submitted by ssva on Mon, 10/06/2008 - 23:11

After I login to the UC500, when I type telnet or try to session into the CUE I get the following

UC520#telnet
% telnet connections not permitted from this terminal
UC520#

I give up and need help solving..

Thanks

Average:

Your rating: None


	#1Submitted by ssva on Wed, 10/08/2008 - 20:53. Telnet issue solved It was not pretty and I got tired of wasting time, so the quiclest resolution was to backup my configs and perfrom a factory reset. DONE! Login or register to post comments


	#2Submitted by jnikolatos on Sat, 10/11/2008 - 08:08. Did you try to configure SSH? Did you try to configure SSH? Becuase this disables telnet. Login or register to post comments


	#3Submitted by ssva on Sat, 10/11/2008 - 22:36. Telnet issues No don't recall doing that. BTW do you happen to know where I can get my hands on a site to site VPN config for UC500's. Login or register to post comments


	#4Submitted by marchern on Sun, 10/12/2008 - 00:14. See under "Configuration" http://supportwiki.cisco.com/wiki/index.php/SBCS_Multi_Site_deployment_-... marcos Login or register to post comments


	#5Submitted by specwar on Tue, 10/07/2008 - 01:30. telnet That's weird, but I can't say that i've ever tried to telnet from the UC520 console. So I'm not sure if it's just you or not. However, to access CUE, try this command: UC520#service-module integrated0/0 session then hit return a couple times. that should telnet you into CUE. Login or register to post comments


	#6Submitted by ssva on Tue, 10/07/2008 - 10:39. Still cant telnet or session into CUE UC520#service-module integrated-Service-Engine 0/0 status Service Module is Cisco Integrated-Service-Engine0/0 Service Module supports session via TTY line 2 Service Module is in Steady state Getting status from the Service Module, please wait.. Cisco Unity Express 3.2.1 CUE running on UC500 UC520#service-module integrated-Service-Engine 0/0 session % telnet connections not permitted from this terminal Any ideas???? Login or register to post comments


	#7Submitted by marchern on Fri, 10/10/2008 - 09:35. Check your VTY config Make sure you don't have something like "transport output none" under your line vty config. Marcos Login or register to post comments

UC500.com