Home » Forums » Cisco VOIP and SBCS » UC500 Configuration

Line ID not displaying on the 7940 with pots line. (Line ID is beeing send)

Submitted by Daleman on Mon, 06/16/2008 - 14:48

Hello,

Can somebody help me with the LINE ID option. When a analouge phone line dails in the number is not beeing displayed on the 7940 phone. The line ID is working and enabled. The configuration of the hardware is as follows.

Siemens VOIP Tel port 1 ----> Freeset wich is displaying the number.
Tel port 1 ---> Cisco UC500 --> 7940 Phone, no Line ID is beeing displayed. (ext. 201)
The freeset and the Cisco are connected to the phone 1 port so the building is ringing :-) after 4 rings the freeset is stopping and the UC takes over for the Vm and attendent options. But the LIne is is missing in the display. Ans i have tested that th line ID is beeing send.

Thanks
Marcel

0
Your rating: None
‹ TFTP Address for IP Communicator Softphone Config General Delivery Mailbox ›
#1Submitted by ttrentler on Fri, 06/27/2008 - 00:19.
ttrentler's picture

try these commands under the voice-port

add the caller-id command to make your fxo port configs look something like this

voice-port 0/1/0
connection plar opx 400
description blah blah blah blah
caller-id enable
#2Submitted by pb on Mon, 06/16/2008 - 18:41.

Have you configure clid and

Have you configure clid and correct cptone under voice-port ?
#3Submitted by Daleman on Tue, 06/17/2008 - 05:03.

eeehh Dont think so..

Can you help me out with this one ?

Thanks
Marcel

Comment viewing options

Select your preferred way to display the comments and click "Save settings" to activate your changes.