Does anyone know if it is possible to have dynamic hunt-group membership with the voice hunt group like you can with the standard ephone hunt groups.

Does anyone know if it is possible to have dynamic hunt-group membership with the voice hunt group like you can with the standard ephone hunt groups.

Hello,

I have a CLIP aware analog phone attached to FXS port 0/0/0 on a UC520.

CLIP (Calling Line Identity Presentation)

Hi,

My 3-party SIP Phone was unable to register with UC520 - Error code 503 - Service Unavailable - registrar unavail or not enabled

We are trying to insert a pause into the dialed number from either the handset or a speed dial entry. Our previous system allowed us to enter a comma to insert a 3 second pause.

Hi,

I'm new to this forum, and I have referenced it few times and so far I love it. Keep up the good work.

Hi

I have the following voice profile

voice user-profile 1
user 201 password 201
number 201,202 type normal

Howdy - I'm troubleshooting a dial-peer problem with a CME system in Singapore.

Greetings forum,

Please save me from offing myself with one of several close-at-hand phone cords. Even fond memories of taking Ted's class may not get me through this difficult time.

Is there any way to make the line buttons on the 7961/7941 do more? For example, can a button be scripted to, with a single press, initiate a Call Forward All and dial said number? I'm thinking no?

Hello, have a small issue with DID and PRI and some long distance calling.

UC520 with
1. FXO trunks connect to PSTN lines
2. SIP trunk codec G729
3. Remote CISCO IP Communicator software codec G729

HI,

can anyone tell where i can find Configuration Guides to implement a
multisite scenario?

We have an ISR 3825 with CCME 7.0.x in our HQ and an UC520 in our BO.